Morris County NJ Antique Furniture Restoration Expert

Antique Furniture Restoration In Morris County NJ

How to repair wood furniture

By Carlos Repair Dover NJ 201-230-1956

If you are looking to restore old wooden furniture and allow the patina of the timber to shine out again. You’ll need these step by step instructions from Carlos repair furniture in Dover NJ.

Neglected old furniture often suffers from a building of dirt and grime. With the diminished colour and lustre resulting in dull appearance. With this in mind. Owners of antique furniture are often left wondering how to restore old wood furniture (often much treasure pieces ) to their former glory.

Thankfully restoring wood furniture is easily done and Carlos has created this easy to follow guide so when you come to restore furniture you’ll know what to do for ultimate success.

Prepare for stripping back

Stripping furniture is messy, but key to wood restoration, so work outside if needed. If works indoors prepare the floor and other furniture nearby and ensure good ventilation, to avoid damaging the finish of the body of the table covering in plastic sheet so that only the top is exposed apply stripper literally with an old brush.

Allow layers to dissolve

For a good result when finishing wood, leave the stripper on for about 30 minutes until the finish. A mix of old varnish and polish has dissolved. The length of time will depend on the composition and thickness of the coating if the stripper hasn’t removed all the layers just re spread the paste and continue to work.

Neutralize the chemical stripper

Neutralize the wood with a pad of the strip wool soaked in white spirit or proprietary wax and polish remover following the grain in wood before use any chemical always read the label before using it. Failure to neutrilise stripper can allow you to reactivate and your wood restoration may not to go to plan.

Clean off the rest of the table

The next step to refinish furniture is to wipe away residues with cotton rags and leave for 24 hours meanwhile clean away dirt and old polish elsewhere by applying wax remover to a steel wood pad or coarse cloth and working in small areas at a time. Leave for few minutes to soften the wax and wipe with a clean cloth before it solidifies.

Improve the sheen and finish when refinishing wood

Once dry apply a coat of finishing oil using a brush or lint free cloth. Allow oil to penetrate for 10 minutes and wipe away the surplus before it gets sticky. Wait for at least 5 hours and gently rub with gauge steel wool, before applying further cloth.

THE FINAL SPRUCE UP WITH WOOD RESTORER

Finally, sparingly apply a thin coat of good furniture wax over the whole table. Leave for an hour at least and polish with a lint-free cloth. To avoid warping caused by drying out of the wood, position furniture away from radiators and fires. Sunlight will bleach the wood, so ensure it’s not placed beneath a window